Operating instructions

Drilling without hammering
Hammer drilling
Chisel adjustment (18 positions)
Chiseling
2.4 Grips
Vibration-absorbing, pivotable side handle with depth gauge
Vibration-absorbing grip
2.5 Protective feature
Mechanical slip clutch
2.6 Lubrication
Oil lubrication
2.7 Items supplied as standard
1 Power tool
1 TE‑C CLICK chuck
1 Side handle with depth gauge
1 Operating instructions
1 Hilti toolbox
1 Cleaning cloth
1 Grease
2.8 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section. The
power tool may otherwise loose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross sec-
tion
1.5 mm² 2.5 mm² 3.5 mm²
14 AWG 12 AWG
Mains voltage 100V 50 m
Mains voltage 110-120
V
30 m 50 m 100 ft 150 ft
Mains voltage 220-240
V
75 m
100 m
Do not use extension cords with 1.25 mm² or 16 AWG conductor cross sections.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The unit must
provide a power output in watts of at least twice the value printed on the rating plate on the power tool. The operating
voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in the 50 – 60 Hz range
and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
en
15
Printed: 19.05.2014 | Doc-Nr: PUB / 5071207 / 000 / 02