Operating Instruction TE 6-A36 (04)

English 7
@
Dust cap
;
Chuck
=
Accessory tool release
%
Depth gauge
&
Function selector switch
(
Forward/reverse switch with safety
lock
)
Control switch
+
Grip
§
Battery release buttons
/
Charge-status and fault indicator
(Li-ion battery)
:
Battery
∙
Connection for the TE DRS-6-A(02)
dust removal module
$
Side handle
£
Work-area light
3.2 Intended use
The product described is a cordless rotary hammer drill. It is designed for drilling in steel,
wood and masonry, for hammer-action drilling in concrete and masonry, and for driving
and removing screws. The product can also be used for light chiseling work on masonry
and surface finishing on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 Lithiumion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated
by the display on the Liion battery. The charge status of the Liion battery is displayed
after pressing one of the two battery release buttons.
Status Meaning
4 LEDs light up. • Charge status: 75 % to 100 %
3 LEDs light up. • Charge status: 50 % to 75 %
2 LEDs light up. • Charge status: 25 % to 50 %
1 LED lights up. • Charge status: 10 % to 25 %
1 LED blinks. • Charge status: < 10 %
Note
Battery charge status cannot be displayed while the control switch is pressed and
for up to 5 seconds after releasing the control switch. If the battery display LEDs
blink, please observe the instructions given in the Troubleshooting section.
3.4 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
You can find other system products approved for your product at your local Hilti Center
or online at: www.hilti.group.
4 Technical data
4.1 Rotary hammer
TE 6A36
Rated voltage
36 V
Weight
8.2 lb
(3.7 kg)
Rated speed under no load
1,050 /min
Printed: 28.08.2017 | Doc-Nr: PUB / 5265030 / 000 / 01