Operating Instruction TE 30-A36 (03)

English 13
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The combihammer is in working order.
Trouble or fault Possible cause Action to be taken
The battery runs down more
quickly than usual.
Battery condition is not optimal. ▶ Replace the battery.
The battery doesn’t engage
with an audible click.
The retaining lugs on the battery
are dirty.
▶ Clean the retaining lugs and refit
the battery.
The control switch can’t be
pressed, i.e. the switch is
locked.
The forward / reverse switch is in
the middle position.
▶ Push the forward / reverse
switch to the right or left.
The drive spindle doesn’t
rotate.
The permissible operating temper-
ature of the combihammer’s elec-
tronics has been exceeded.
▶ Allow the combihammer to cool
down.
The battery is discharged. ▶ Change the battery and charge
the empty battery.
The combihammer switches
itself off automatically.
The overload cut-out has been
activated.
▶ Release the control switch.
Allow the combihammer to cool
down. Press the control switch
again. Reduce the load on the
tool.
The combihammer or the
battery gets very hot.
Electrical fault. ▶ Switch the combihammer off
immediately. Remove the
battery and keep it under
observation. Allow it to cool
down. Contact Hilti service.
The combihammer has been
overloaded (application limits
exceeded).
▶ Select a tool that is suitable for
the intended purpose.
The insert tool can’t be re-
leased.
Chuck not pulled back fully. ▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
Printed: 30.04.2019 | Doc-Nr: PUB / 5351707 / 000 / 03