Operating Instruction GFB 6X-A22 (01)

*2241314*
2241314 English 5
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Overview of the product 1
@
Eccentric screw
;
Locking screw for swivel arm
=
Lockable on/off switch
%
Adjusting knob for speed
&
Battery
(
Battery release button
)
Dust filter
+
Grip
§
Casing cover
/
Drive roller
:
Securing screws for file arm
∙
File arm
$
Adjusting screw for file arm
£
Abrasive belt
|
Contact roller
3.2 Intended use
The product described is a hand-held, cordless band file. It is designed for grinding and polishing metallic
surfaces in awkward places, without use of water.
▶ Use only Hilti Liion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Possible misuse
Do not use the product for wet grinding.
Do not use the product to work on hazardous or flammable materials (e.g. asbestos, magnesium, wood).
3.4 Items supplied
Band file, side handle, file arm, Torx wrench, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group
3.5 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool’s performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.6 Li-ion battery charge status display
The charge status of the Liion battery is displayed after one of the two battery release buttons is pressed.
Status Meaning
4 LEDs light. Charge status: 75 % to 100 %
3 LEDs light. Charge status: 50 % to 75 %
2 LEDs light. Charge status: 25 % to 50 %