Operating Instruction AG 600-A36 (02)

14 English
5.4 Fitting or removing the guard
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
▶ Observe the instructions for fitting the applicable guard.
5.4.1 Fitting the guard
The guard is equipped with locating lugs that ensure only guards of a type suitable for use with the
power tool can be fitted. The locating lugs of the guard fit into the guard mount on the power tool.
1. Fit the guard onto the drive spindle collar so that the two triangular marks on the guard and on the power
tool are in alignment.
2. Press the guard onto the drive spindle collar.
3. Press the guard release button.
4. Rotate the guard until it engages and the guard release button jumps back into its original position.
5.4.2 Adjusting the guard
▶ Press the guard release button and then rotate the guard until it engages in the desired position.
5.4.3 Removing the hood
1. Press the guard release button and then rotate the guard until the triangular marks on the guard and the
power tool are in alignment.
2. Remove the guard.
5.5 Fitting or removing the front cover
The front cover, when used, is clipped onto the guard.
Printed: 07.03.2018 | Doc-Nr: PUB / 5246615 / 000 / 01