Operating Instruction AG 600-A36 (02)

*2106619*
2106619 English 7
• The tool can be used for cutting, slitting and grinding mineral materials only in combination with the
appropriate guard (optional accessory).
• It is recommended that a dust removal system consisting of matched components, i.e. dust removal
hood and a suitable Hilti vacuum cleaner, are used for working on mineral materials such as concrete or
stone. These protect the operator and increase the life of the tool and accessory tools used.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 Items supplied
Angle grinder, side handle, standard guard, front cover, clamping flange, clamping nut, wrench, operating
instructions.
3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool’s performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.5 Guard with front cover 2
When grinding with straight grinding discs and cutting with cutting discs in metalworking applications,
use the standard guard with front cover.
3.6 Dust hood for cutting: DC-EX 125/5" C compact hood (accessory) 3
When cutting mineral materials with diamond cutting discs, use the DC-EX 125/5" C compact hood.
CAUTION Use of this hood for working on metal is prohibited.
3.7 DG-EX 125/5" dust hood for grinding (accessory) 4
The grinding system is suitable only for occasional use with diamond cup wheels for grinding mineral
materials.
CAUTION Use of this hood for working on metal is prohibited.
3.8 Consumables
Use only synthetic-resin-bonded, fiber-reinforced discs with a maximum Ø of 6" approved for a rotational
speed of at least 8500 rpm and a peripheral speed of 80 m/s.
The maximum grinding disc thickness is 1/4" and the maximum cutting disc thickness is 1/8".
WARNING! When cutting or slitting with abrasive cutting discs always use the standard guard with
the additional front cover, or a fully enclosing dust hood.
Discs
Application Designation Material
Abrasive cutting disc Cutting, slitting ACD Metal
Diamond cutting disc Cutting, slitting DC-TP, DC-D (SPX,
SP, P)
Mineral
Abrasive grinding disc Rough grinding AG-D, AF-D, AN-D,
AG-D type 27
Metal
Diamond grinding disc Rough grinding DG-CW (SPX, SP,
P)
Mineral
Wire brushes Wire brushes 3CS, 4CS, 3SS,
4SS
Metal
Printed: 07.03.2018 | Doc-Nr: PUB / 5246614 / 000 / 01