Operating instructions
*2184329*
2184329 English 13
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group | USA: www.hilti.com
7.2 Cleaning the inside of the nosepiece
1. Remove the fastener guide. → page 9
2. Clean the inside of the nosepiece.
3. Insert the fastener guide. → page 9
8 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The spring element is not ten-
sioned; no status indication.
The battery is empty. ▶ Change the battery.
The battery is not fitted correctly. ▶ Insert the battery. → page 8
The spring element is not ten-
sioned, the status indicator
blinks green and 1 battery
charge status LED blinks.
The battery is empty. ▶ Change the battery.
Battery temperature too low. ▶ Allow the battery to warm up
slowly to room temperature.
The spring element is not re-
tensioned, the status indica-
tor blinks green and 4 battery
charge status LEDs blink.
The fastening tool has overheated. ▶ Allow the fastening tool to cool
down.
The spring element is not ten-
sioned and the status indica-
tor blinks red.
The fastener guide is not fitted
correctly.
▶ Insert the fastener guide.
→ page 9
The spring element is not ten-
sioned and the status indica-
tor lights red.
System fault. ▶ Remove the battery. → page 9
▶ Insert the battery. → page 8
The fastener guide cannot
be pressed in and the status
indicator lights green.
The magazine is empty. ▶ Load the magazine. → page 9
The nail pusher is jammed. ▶ Remove the nail strips from
the magazine and clean the
magazine.
Printed: 19.07.2018 | Doc-Nr: PUB / 5377482 / 000 / 02