Operating Instruction SC 60W-A36 (01)

English 25
Malfunction Possible cause Action to be taken
No response from
the LEDs on the bat-
tery.
The battery is too hot or
too cold.
▶ Bring the battery to
the recommended
working temperature.
1 LED on the battery
flashes.
The battery is
discharged.
▶ Change the battery
and charge the empty
battery.
The battery is too hot or
too cold.
▶ Bring the battery to
the recommended
working temperature.
4 LEDs flash. The circular saw was
overloaded briefly.
▶ Release the control
switch and then press
it again.
The overheating preven-
tion cut-out has been
activated.
▶ Allow the circular saw
to cool down and
clean the air vents.
10 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking
gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local govern-
mental garbage disposal or public health and safety resources for disposal
instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
11 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about
the warranty conditions.
Printed: 04.06.2018 | Doc-Nr: PUB / 5389748 / 000 / 01