Manualshelf

Use and Care Manual

ManualsBrandsHilti ManualsDrillsSF 10-Watt 22-Volt Cordless Drill Driver with Active Torque Control 4-Speeds for High Torque Applications with Tool Bag
11121314151617181920
8 English 2130486
*2130486*
6 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function selection during operation.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool in the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.
6.2 Selecting the gear 5
▶ Select the desired gear by adjusting the two gear selector switches.
6.3 Switching on
▶ Press the control switch.
The running speed can be controlled smoothly right up to maximum speed by varying how far the
control switch is pressed in.
6.4 Drilling
1.
Set the torque and operating mode selector ring to the symbol.
2. Set the forward/reverse switch to the “forward” position.
6.5 Screwdriving
1. Set the torque and operating mode selector ring to the required torque.
2. Set the forward/reverse switch to the desired direction of rotation.
6.6 Switching off
▶ Release the control switch.
6.7 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
7 Care, maintenance, transport and storage
7.1 Care and maintenance of cordless tools
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Printed: 23.03.2018 | Doc-Nr: PUB / 5255074 / 000 / 01