Use and Care Manual

*2130486*
2130486 English 5
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Do not expose batteries to high temperatures, the direct heat of the sun, and keep them away
from fire. There is a risk of explosion.
Do not disassemble, squash or incinerate batteries and do not subject them to temperatures over
80°C (176°F). This presents a risk of fire, explosion or injury through contact with caustic substances.
Do not continue to use or attempt to charge damaged batteries (e.g. batteries with cracks, broken
parts, bent or pushed-in/pulled-out contacts).
If the battery is too hot to touch it may be defective. In this case, place the power tool in a non-
flammable location, well away from flammable materials, where it can be kept under observation
and allowed to cool down. Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Overview of the product 1
@
Side handle
;
Keyless chuck
=
Torque and drilling mode selector ring
%
Gear selector switch
&
Forward/reverse selector switch with safety
lock
(
Control switch (with electronic speed control)
)
Grip
+
Light to illuminate the work area
§
Belt hook (optional)
/
Liion battery
:
Battery release button
State of charge and fault display (Li-ion bat-
tery)
3.2 Intended use
The product described is a hand-held cordless drill / driver. It is designed to be used for driving and removing
screws and for drilling in steel, wood and plastic.
Use this product only with Hilti Liion batteries of the B18 / B22 series.
Use only the Hilti battery chargers of the C4/36 series for these batteries.
3.3 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about its own axis in the opposite
direction. ATC detects this sudden pivoting movement of the power tool and switches the tool off immediately.
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by releasing the control switch
for a moment and then pressing the switch again.
3.4 Liion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Liion battery. The charge status of the Liion battery is displayed after pressing one of the two battery
release buttons.
Printed: 23.03.2018 | Doc-Nr: PUB / 5255074 / 000 / 01