Operating Instruction R 6-22 (01)

*2309425*
2309425 English 11
Malfunction Possible cause Action to be taken
Border of the battery symbol
flashes, no segment of the
state of charge indicator filled
(the indicator assumes this
state for a short time before
the appliance switches itself
off).
Battery too hot ▶ Wait until the battery cools
down.
Battery too cold ▶ Wait until the battery warms up.
Battery defective ▶ Check the battery by pressing
the two buttons at the sides.
If the LEDs light up the radio
might be defective. If the LEDs
do not light up the battery is
defective.
▶ Contact Hilti Service.
Settings such as clock time
are no longer saved in mem-
ory.
Batteries discharged ▶ Replace the back-up batteries.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 FCC statement (applicable in US) / IC statement (applicable in Canada)
This device has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are intended to ensure adequate protection against
electromagnetic interference when the device is operated in areas used for commercial purposes.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause interference to radio communications. The user must
bear costs incurred due to interference that operation of this device in residential areas can cause.
This device is in compliance with paragraph 15 of the FCC rules and the RSS210 specifications of ISED.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti may restrict the user’s authorization to
operate the equipment.
13 Further information
For more information on operation, technology, environment and recycling, follow this link:
qr.hilti.com/manual?id=2309425