Operating Instruction SC 30WR-22 (01)

*2264108*
2264108 English 17
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Installing the saw blade 2
Check that the blade to be fitted complies with the technical
requirements and that it is well sharpened. A sharp saw blade is an
essential requirement for a perfect cut.
1. Clean the mounting flange and the clamping flange.
2. Slip the mounting flange right way round on to the arbor.
3. Open the lower guard.
4. Insert the new saw blade.
Note the direction-of-rotation arrows on the saw blade and on the
product. They must point in the same direction.
5. Install the outer clamping flange the right way round.
6. Install the clamping screw.
7. Insert the hex key into the saw blade clamping screw.
8. Press and hold down the spindle lock button.
9. Use the hex key to tighten the clamping screw.
10. Check that the saw blade is seated correctly.
11. Insert the hex key into the hole provided for the purpose.
5.5 Removing the saw blade 3
WARNING
Risk of burns and cut injuries at saw blade, clamping screw and
clamping flange The consequences can be burns and cut injuries.
▶ Wear protective gloves when changing saw blades.
1. Press and hold down the spindle lock button.
2. Use the hex key to slacken the clamping screw.
3. Remove the clamping screw and the clamping flange.
4. Open the lower guard and remove the saw blade.
If necessary, the mounting flange can be removed for cleaning.
5.6 Adjusting the cutting depth 4
For optimum cutting conditions, always set a cutting depth 5-10 mm
more than the thickness of the material to be cut.
1. Release the clamping lever.