Operating Instruction BX 3-ME (02)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Preparing the tool for use
- 6 Operation
- 7 Care and maintenance
- 8 Transport and storage of cordless tools
- 9 Troubleshooting
- 10 Disposal
- 11 Manufacturer’s warranty
- 12 FCC statement (applicable in US) / IC statement (applicable in Canada)
10 English
3. Check that the battery is securely seated in the fastening tool.
5.3 Removing the battery
1. Switch off the fastening tool. → page 14
2. Press and hold down the two release buttons.
3. Pull the battery to the rear and out of the device.
5.4 Removing the fastener guide
1. Switch off the fastening tool. → page 14
2. Remove the battery. → page 10
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 15
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow.
◁ The fastener guide will be released.
6. Remove the fastener guide.
5.5 Inserting the fastener guide
1. Switch off the fastening tool. → page 14
2. Remove the battery. → page 10
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 15
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow and hold it in this
position.
6. Slide the fastener guide into the nosepiece until it is heard to engage.
7. Release the fastener guide locking catch.
◁ The fastener guide jumps to the middle position.
8. Grip and pull the fastener guide to check that it is securely seated.
Printed: 19.07.2018 | Doc-Nr: PUB / 5377202 / 000 / 02