Operating Instruction BX 3-ME (02)

8 English
Status Meaning
Off • The fastening tool is switched off
The LED shows green. • The fastening tool is switched on and ready for
use
The LED flashes green every 3 seconds. • The fastening tool is in stand-by mode. Press
the nose of the tool against the working surface
to switch it on
The LED flashes green. • The fastening tool is too hot or the battery has
insufficient power; see “Troubleshooting”
The LED flashes red. • Malfunction; see “Troubleshooting”
The LED shows red. • Malfunction; see “Troubleshooting”
3.7 Indication of battery charge status
When one of the battery release buttons is pressed the display indicates the battery’s state of charge.
Reliable indication of the charge status is not possible while a fastener is being driven or immediately
after a fastener is driven.
Status Meaning
All four LEDs light green. • Charge status is 75 % to 100 %.
Three LEDs light green. • Charge status is 50 % to 75 %.
Two LEDs light green. • Charge status is 25 % to 50 %.
One LED lights green. • Charge status is 10 % to 25 %.
One LED blinks green. • Charge status is below 10 %. The tool is ready
for use.
3.8 Batteries
Battery performance drops at low temperatures.
When battery performance drops, it takes longer (than with a fully charged battery) until the fastening tool is
ready to drive the next fastener.
If you continue to operate the fastening tool after battery performance drops, the fastening tool will switch
itself off automatically before damage to the battery occurs.
3.9 Items supplied
BX 3-ME fastening tool, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4 Technical data
4.1 Fastening tool
Weight B 22/2.6 LiIon (02)
8.4 lb
(3.8 kg)
B 22/3.0 LiIon (01)
8.6 lb
(3.9 kg)
B 22/5.2 Li-Ion (01)
9.0 lb
(4.1 kg)
Nail length (collated nails)
0.6 in …0.9 in
(14 mm …24 mm)
Nail length (single nails)
1.2 in …1.4 in
(30 mm …36 mm)
Printed: 19.07.2018 | Doc-Nr: PUB / 5377202 / 000 / 02