Operating Instruction SF 6-A22/SF 6H-A22 (02)

12 English 2231427
*2231427*
3. Secure the bit holder with the two screws.
4. Insert the battery. → page 10
5.7 Hilti Installing the retaining strap (optional) 5
ATTENTION
Damage to the product and / or the lanyard. Incorrect handling can result
in damage to the product and/or lanyard.
▶ Do not use a metal chain as a lanyard. Do not use lanyards longer than
2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to
use the Hilti retaining strap.
The retaining strap allows a securing cord or lanyard to be attached.
When working with the product, you must comply with national regula-
tions for working at heights.
1. Remove the battery. → page 11
2. Insert the two tabs on the retaining strap into the slots on each side of the
base.
3. Secure the retaining strap with the screws supplied.
4. Insert the battery. → page 10
5.8 Selecting the gear 6
▶ Select the gear.
5.9 Setting forward or reverse rotation 7
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse selector switch to forward or reverse rotation, as
applicable.
5.10 Inserting / removing the accessory tool 8
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Open the keyless chuck.
3. Insert the accessory tool into the chuck or remove it from the chuck.
4. Tighten the keyless chuck.
5. Check that the accessory tool is held securely.
Printed: 19.08.2019 | Doc-Nr: PUB / 5467429 / 000 / 01