Operating Instruction SF 6-A22/SF 6H-A22 (02)

*2231427*
2231427 English 9
Battery state of charge cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given
in the Troubleshooting section.
3.5 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-
acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about
its own axis in the opposite direction. ATC detects this sudden pivoting
movement of the power tool and switches the tool off immediately.
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by
releasing the control switch for a moment and then pressing the switch
again.
3.6 Overload and overheating indicator
The power tool has an electronic system to protect against overload and
overheating. The power tool switches off automatically in the event of
overload or overheating. The power tool might not restart immediately when
the control switch is pressed after being released (cooling phase).
4 Technical data
SF 6-A22 SF 6H-A22
Rated voltage
21.6 V
DC
21.6 V
DC
Weight
6.2 lb
(2.8 kg)
6.2 lb
(2.8 kg)
Speed 1st
gear
0 /min …
490 /min
0 /min …
490 /min
2nd
gear
0 /min …
2,000 /min
0 /min …
2,000 /min
Torque (soft joint)
≤ 65 Nm ≤ 65 Nm
Impact speed
•/• 36,000 /min
Ambient temperature for opera-
tion
1 ℉ … 140 ℉
(−17 ℃ … 60 ℃)
1 ℉ … 140 ℉
(−17 ℃ … 60 ℃)
Storage temperature
−4 ℉ … 158 ℉
(−20 ℃ … 70 ℃)
−4 ℉ … 158 ℉
(−20 ℃ … 70 ℃)
Printed: 19.08.2019 | Doc-Nr: PUB / 5467429 / 000 / 01