Operating Instruction BX 3 / BX 3-L (02)

16 English
Trouble or fault Possible cause Action to be taken
The spring element is not re-
tensioned, the status indica-
tor flashes green and 4 bat-
tery charge status LEDs flash.
The fastening tool has overheated. ▶ Allow the fastening tool to cool
down.
The spring element is not ten-
sioned and the status indica-
tor flashes red.
The fastener guide is not fitted
correctly.
▶ Insert the fastener guide.
→ page 10
The spring element is not ten-
sioned and the status indica-
tor lights red.
System fault. ▶ Remove the battery. → page 10
▶ Fit the battery. → page 9
The fastener guide cannot
be pressed in and the status
indicator lights green.
The magazine is empty. ▶ Load the magazine. → page 11
The nail pusher is jammed. ▶ Remove the nail strips from
the magazine and clean the
magazine.
Nail jammed in the fastener guide. ▶ Release the jammed nail.
→ page 14
The fastener guide is jammed
in the pressed-in state.
Dirt between the fastener guide
and the nosepiece.
▶ Clean the inside of the nose-
piece. → page 15
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 FCC statement (applicable in US) / IC statement (applicable in Canada)
The product complies with part 15 of the FCC Rules and RSS210 of the IC.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti may restrict the user’s authorization to
operate the equipment.
Printed: 19.07.2018 | Doc-Nr: PUB / 5376261 / 000 / 01