Operating Instruction BX 3 / BX 3-L (02)

English 11
5.5 Working safely with the belt and scaffold hook
▶ Before beginning work, make sure that the belt hook / scaffold hook is securely attached to the tool.
▶ Use the belt hook / scaffold hook only when necessary. Lay the tool down in a safe place when it is not
in use for a long period.
5.6 Loading for magazine operation
WARNING
Risk of crushing! Allowing the nail pusher to snap back under spring pressure may result in finger injuries
and cause damage to the fastening tool.
▶ When pulling the nail pusher down, take care to ensure that it engages securely. Do not allow the nail
pusher to jump back under spring pressure.
1. Pull the nail pusher down until it engages.
2. Slide the nail strips into the magazine (a maximum of 3 strips of 10 nails).
3. Hold the nail pusher securely and press the nail pusher release button.
4. Guide the nail pusher back until it contacts a nail.
6 Types of work
6.1 Using the support leg
On an even working surface, the support leg makes it easier to hold the fastening tool perpendicular as
attention then only has to be paid to lateral alignment. On uneven surfaces it may necessary to retract the
support leg in order to ensure that the fastener guide is perpendicular to the working surface.
Printed: 19.07.2018 | Doc-Nr: PUB / 5376261 / 000 / 01