Use and Care Manual

***** For internal use only ***** 11.08.2016 / 12:48:13 - H2\DOK-Projekt\System\SD_5000-A22\ENU\SD4500_P3
11
5.6 Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in
this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go.
5.7 Removing the battery
Press both battery release buttons simultaneously and pull the battery out of the screwdriver.
Printed: 11.08.2016 | Doc-Nr: PUB / 5295850 / 000 / 00