Use and Care Manual

***** For internal use only ***** 11.08.2016 / 12:48:13 - H2\DOK-Projekt\System\SD_5000-A22\ENU\SD4500_P3
8
@
Chuck
;
Power tool / accessory interface (snap-on
connection)
=
Universal hook
%
Motor cooling air intake
&
Grip
(
Motor cooling air intake
)
Forward / reverse selector switch with
safety lock
+
Control switch (with electronic speed
control)
§
Lockbutton for continuous operation
/
Belt hook
:
Charge state and fault display (Li-ion
battery)
∙
Battery release buttons
$
Depth gauge
3.2 Intended use
The product described is a hand-held cordless drywall screwdriver equipped with a clutch.
Use only the drywall screws specified in the technical data.
The screwdriver handles best when gripped in the in-line position.
The motor cooling air is drawn in through the cooling air slots and blown out of the screwdriver through the
air vents.
▶ Use only Hilti Liion batteries from the B 18 / B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series with these batteries.
3.3 Charge state display
The charge state of the Liion battery is displayed after pressing one of the release buttons lightly (press only
until slight resistance is felt).
Status Meaning
4 LEDs light. • Charge state: 75 % to 100 %
3 LEDs light. • Charge state: 50 % to 75 %
2 LEDs light. • Charge state: 25 % to 50 %
1 LED lights. • Charge state: 10 % to 25 %
1 LED blinks. • Charge state: < 10 %
Note
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
3.4 Items supplied
Drywall screwdriver, operating instructions
Note
You can find other system products approved for use with your product at your local Hilti Center or
online at: www.hilti.com.
3.5 Overloading and overheating protection
The drywall screwdriver is protected from overloading and overheating by an automatic cut-out. Overloading
or overheating is indicated by the four LEDs blinking. After overheating, when the control switch is pressed
to restart the screwdriver, there may be a delay before the screwdriver restarts.
4 Technical data
4.1 Screwdriver
Rated voltage
21.6 V
Weight
4.6 lb
(2.1 kg)
Rated speed under no load
0 Hz …83.3 Hz
(0 /min …5,000 /min)
Printed: 11.08.2016 | Doc-Nr: PUB / 5295850 / 000 / 00