Use and Care Manual

RPM
Obligation signs
Wear eye
protection
Wear ear
protection
Wear
protective
gloves
Symbols
Read the
operating
instructions
before use
Return waste
material for
recycling.
Volts Direct current
Rated speed
under no load
Revolutions per
minute
Revolutions
per minute
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.:
2. Description
2.1 Use of the product as directed
The ST 1800ತA18 is a hand-held cordless screwdriver for fastening profile metal sheets, metal sheets and
sandwich panels in metal construction.
This power tool is designed for driving and removing self-drilling and self-tapping screws in appropriate
materials and material thicknesses.
The power tool is equipped with 2 clutch systems: Depth gauge coupling and torque coupling.
It is possible to use a stand-up tool for driving collated screws.
Only the specified screwdriving accessories and other specified accessories should be used.
The motor cooling air is drawn in through the ventilation slots and blown out of the tool through the air exit.
The power tool is suitable for use by right or left-handed persons.
An ergonomically designed grip with synthetic rubber covering provides a comfortable, secure hold and
reduces fatigue.
To use the power tool to its best potential, we recommend that you hold the power tool by the in-line grip.
The specially-designed pressure transfer surface at the top end of the ergonomic grip allows additional
pressures to be applied with your other hand without discomfort.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Do not use the battery as a power source for other unspecified appliances.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
Do not use the power tool where there is a risk of fire or explosion.
en
2