Use and Care Manual

7. Operation
CAUTION
Wear protective gloves when changing insert tools
as the insert tools get hot during use.
CAUTION
Working on the material may cause it to splinter. Wear
eye protection and protective gloves. Splintering
material presents a risk of injury to the eyes and
body.
7.1 Setting forward or reverse rotation 3
NOTE
The forward / reverse switch is used to select the
direction of rotation of the drive spindle. An interlock
prevents switching while the motor is running. The
control switch is locked when the forward / reverse
switch is in the middle position. Push the forward /
reverse switch to the left (when the power tool is held
in the working direction) to select forward rotation.
Push the forward / reverse switch to the right (when
the power tool is held in the working direction) to
select reverse rotation.
7.2 Torque selection 4
Turn the torque clutch setting ring to the desired
torque setting.
7.3 Safe operation 5
WARNING
The depth gauge and chuck must not be used as a
grip. A screw coming into contact with a concealed
electric cable may result in electric shock.
CAUTION
Always hold the tool by the grip and/or with the hands
on plastic parts of the casing.
7.4 Switching on / off
1. Press the tool against the work surface.
The drive spindle begins to rotate.
2. The speed of the power tool can be controlled
smoothly (increased from zero to maximum) by
pressing the control switch gradually.
3. To switch the tool off, release the control switch.
7.5 Pressure transfer surface
The pressure transfer surface allows the user to apply
higher pressures to the power and screw, thereby
optimizing drilling and screwdriving. It makes the
tool less tiring to use.
Apply pressure to the pressure transfer surface with
your other hand when drilling and screwdriving.
This will significantly reduce the load on the hand and
arm holding the tool.
7.6 Lockbutton for sustained operation
NOTE
The lockbutton for sustained operation allows the
motor to run continuously without need for constant
pressure on the control switch.
7.6.1 Switching on in sustained operating mode
1. Press the control switch fully.
2. While maintaining pressure on the control
switch, press the lockbutton and then release
the control switch.
7.6.2 Switching off after sustained operation
Press the control switch. The lockbutton returns to
its original position.
7.7 Guard 6
When the depth gauge is not fitted, the guard protects
the depth gauge holder from dirt and damage.
Fit the guard by pushing it onto the tool from the
front.
Remove the guard by pulling it away from the tool.
7.8 Depth gauge
Attachment for correctly fastening screws which have
a sealing washer.
en
9