Use and Care Manual

5.3 Fitting the accessory tool

1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.

2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.

3. Open the keyless chuck.

4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and

several clicks are heard.

5. Check that the accessory tool is held securely.

5.4 Removing the accessory tool

1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.

2. Open the keyless chuck.

3. Pull the accessory tool out of the keyless chuck.

5.5 Switching on

▶ Press the control switch.

Note

Speed can be controlled steplessly right up to maximum by varying how far the control switch is

pressed in.

5.6 Switching off

▶ Release the control switch.

5.7 Drilling

Set the torque and operating mode selector ring to the symbol.

2. Set the forward/reverse switch to the “forward” position.

5.8 Screwdriving

1. Set the torque and operating mode selector ring to the required torque.

2. Set the forward/reverse switch to the desired direction of rotation.

5.9 Setting forward or reverse rotation

Note

An interlock prevents switching while the motor is running.

The control switch is locked when the forward/reverse switch is in the middle position (safety lock).

▶ Set the forward/reverse switch to the desired direction of rotation.

Printed: 27.07.2016 | Doc-Nr: PUB / 5293242 / 000 / 00