Operating Instruction SL 2-A12 (01), SL 2-A22 (1)

8 English
7 Transport and storage
7.1 Transport and storage of cordless tools
Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may
occur if the battery is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage
the tool.
▶ Always remove the battery before storing the tool.
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or
unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy
the problem by yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault Possible cause Action to be taken
The battery does not
engage with an audible
double click.
The retaining lugs on the
battery are dirty.
▶ Clean the retaining lugs
and push the battery in
until it engages.
1 LED flashes.
The device does not
work.
The battery is discharged. ▶ Change the battery and
charge the empty battery.
The battery is too hot or too
cold.
▶ Allow the battery to cool
down or warm up slowly
to room temperature.
Printed: 21.04.2017 | Doc-Nr: PUB / 5346584 / 000 / 00