Use and Care Manual
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Before use
- 6 Operation
- 6.1 Operation without use of the power outlet on the appliance
- 6.2 Operation with use of the power outlet on the appliance
- 6.3 Picking up dry dust
- 6.4 Picking up liquids
- 6.5 After use of the vacuum cleaner
- 6.6 Emptying dry dust from the waste material container
- 6.7 Emptying the waste material container when no dust bag is fitted (picking up liquids)
- 7 Care, maintenance, transport and storage
- 8 Troubleshooting
- 9 Disposal
- 10 Manufacturer’s warranty
- Mode d'emploi original
- 1 Indications relatives à la documentation
- 2 Sécurité
- 3 Description
- 4 Caractéristiques techniques
- 5 Mise en service
- 6 Utilisation
- 6.1 Fonctionnement sans utilisation de la prise de l'appareil
- 6.2 Fonctionnement avec utilisation de la prise de l'appareil
- 6.3 Aspiration de poussières sèches
- 6.4 Aspiration de liquides
- 6.5 Après aspiration
- 6.6 Vidage de la cuve de récupération de saletés en cas de poussières sèches
- 6.7 Vidage de la cuve de récupération de saletés sans sac à poussières (en cas d'aspiration de liquides)
- 7 Nettoyage, entretien, transport et entreposage
- 8 Aide au dépannage
- 9 Recyclage
- 10 Garantie constructeur
- Manual de instrucciones original
- 1 Información sobre la documentación
- 2 Seguridad
- 3 Descripción
- 4 Datos técnicos
- 5 Puesta en servicio
- 6 Manejo
- 6.1 Funcionamiento sin uso de la toma de corriente del aspirador
- 6.2 Funcionamiento con uso de la toma de corriente de la herramienta
- 6.3 Aspiración de polvo seco
- 6.4 Aspiración de líquidos
- 6.5 Después de aspirar
- 6.6 Vaciado del depósito de suciedad con polvo seco
- 6.7 Vaciado del depósito de suciedad sin saco para polvo (con líquidos)
- 7 Cuidado, mantenimiento, transporte y almacenamiento
- 8 Ayuda en caso de averías
- 9 Reciclaje
- 10 Garantía del fabricante
- Manual de instruções original
- 1 Indicações sobre a documentação
- 2 Segurança
- 3 Descrição
- 4 Características técnicas
- 5 Antes de iniciar a utilização
- 6 Utilização
- 6.1 Trabalhar sem o aparelho utilizando a tomada embutida no aparelho
- 6.2 Trabalhar com o aparelho utilizando a tomada embutida no aparelho
- 6.3 Aspirar pós secos
- 6.4 Aspirar líquidos
- 6.5 Após a aspiração
- 6.6 Esvaziar o contentor em caso de pós secos
- 6.7 Esvaziar o contentor sem saco colector do pó (no caso de líquidos)
- 7 Conservação, manutenção, transporte e armazenamento
- 8 Ajuda em caso de avarias
- 9 Reciclagem
- 10 Garantia do fabricante
English 7
5.3 Fitting/changing the plastic dust bag 3
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Use a cable tie to close the plastic dust bag below the punched holes.
5. Remove the plastic dust bag.
6. Clean the waste material container with a cloth.
7. Fit a new plastic dust bag (see instructions printed on it) in the waste material container.
8. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
6 Operation
DANGER
Electrical hazards. Fatal or serious injury may result if the vacuum cleaner is not correctly connected
to the electric supply.
▶ Connect the vacuum cleaner only to a properly earthed/grounded power source.
WARNING
Risk of injury. Damage to the filter system may allow harmful dust (health hazard) to escape.
▶ In an emergency (e.g. filter ruptured), switch the vacuum cleaner off, unplug the supply cord from
the power outlet and have the vacuum cleaner checked by a trained and qualified person before
further use.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may
run away out of control if the wheel brakes are not engaged.
▶ Engage the wheel brakes so that the vacuum cleaner stands securely.
6.1 Operation without use of the power outlet on the appliance
1. Check that the switch on the appliance is in the “OFF” position off before plugging the supply cord into
a power outlet.
2. Plug the vacuum cleaner’s supply cord into the power outlet.
3. Turn the control switch to the “ON” position.
6.2 Operation with use of the power outlet on the appliance
Note
The power outlet on the appliance is to be used only for powering electric tools directly from the
vacuum cleaner.
The operating instructions and safety instructions for the electric tool plugged into the power outlet on
the vacuum cleaner must be observed.
1. Unplug the vacuum cleaner’s supply cord from the power outlet.
2. Check that the maximum power drawn by the electric tool is below the maximum permissible output of
the power outlet on the vacuum cleaner (please refer to the “Technical data” section of the operating
instructions and information printed at the power outlet on the appliance).
3. Check to ensure that the electric tool is switched off before plugging its supply cord into the power outlet.
4. Plug the electric tool’s supply cord into the power outlet on the vacuum cleaner.
5. Plug the vacuum cleaner’s supply cord into the power outlet.
6. Turn the control switch to the “Auto” position.
7. Switch on the power tool.
Note
The vacuum cleaner will continue to run for a short time after switching off the electric tool in order
to ensure that all dust is removed from the suction hose.
Printed: 22.02.2017 | Doc-Nr: PUB / 5334126 / 000 / 00