Instructions

Network Bullet Camera·Quick Start Guide
21
21
Steps:
1. Feed the plugless network cable ⑦ through the lock nut ⑥,
waterproof rubber gasket ⑤ (the rubber gasket inset ridge must
face the waterproof endcap), and the waterproof endcap ④ in
order.
2. Crimp an RJ-45 network plug ③onto the end of the cable, taking
care to insert the twisted pairs of wires in correct order.
3. Place the O-type gasket ② onto the end of the camera’s network
interface socket ①.
4. Insert the network plug ③ into the camera’s network interface
socket ①.
5. Insert the waterproof rubber gasket ⑤ into the waterproof
endcap ④, and secure lock nut ⑥ with the waterproof endcap
④.
6. Align the snap on the waterproof endcap ④ with the notch on
the camera’s network interface socket ①, and then secure the
waterproof endcap ④ to the camera’s network interface socket
① to finish installation.