User Manual

38
Chapter 4 Boot and Configuration | Hillstone
Hillstone Multi-core Security Appliance Installation Manual
Chapter 4 Boot and Configuration
Introduction
This chapter describes the initial system boot and basic configuration of Hillstone
SG-6000 series, using a PC as the console terminal.
Establishing a Configuration Environment
Hillstone security appliances support both local and remote configuration.
Administrators can use the following configuration methods.
 Console (CON) connection
 WebUI
 Telnet or SSH
Console (CON) Connection
For initial system configuration, you have to establish a Console connection
environment (connect the device to a configuration terminal through its Console
port).
To connect the PC to the CON port of the firewall, take following steps:
1. Set up a local configuration environment. Connect the Console port to the
serial port of a PC through a console cable, as shown in Figure 4-1:
Figure 4-1: Console Port Configuration
2. Run the terminal emulation program on the PC (e.g. hyper terminal of
Windows XP/Windows 2000) to set up a connection. Set the parameters of the
terminal session to 9600bps, 8 data bits, 1 stop bit, none parity, and none
flow control, as shown in Figure 4-2:
CON port
Console cable
RS-232 serial port
PC