Manualshelf

User Manual

ManualsBrandsHillstone Networks ManualsElectronicsFirewall Appliance
31323334353637383940
24
Chapter 1 Introduction | Hillstone
Hillstone Multi-core Security Appliance Installation Manual
Expansion Slot
The chassis height of SG-6000-G5150, SG-6000-M8860, and SG-6000-M7260 is 2U
with four half-U expansion slots (Slot 1-4); SG-6000-G2120 is 1U height with two
half-U expansion slots (Slot 1-2). Follow the rules below when inserting the
expansion modules into expansion slots.
Half-U expansion slot fits in any slot.
1U height expansion modules can only be installed in Slot2 and Slot4.
For SG-6000-G2120, the expansion module FEC-HD-160 can only be inserted
in Slot1.
Some appliances support more than one expansion modules of the same type.
Cautions:
Cover the expansion slot with blank panel if the slot has no expansion
module installed.
For detailed information of expansion modules, see Hillstone Multi-core
Security Appliance Expansion Modules Manual.
SD Card Slot
SG-6000-M3108 has a SD card slot for SD storage card on the front panel. SD card
stores the data of the Network Behavior Control logs.
To install an SD card, take the following steps:
1. Ensure that the write protection switch is off so that it can be written.
2. Face the front panel of the appliance.
3. Insert the SD card with the metal contact side facing down and push it slightly
into the card slot. Do not push too hard with force to avoid damage to the slot
or the card.
4. Stick the seal label on the SD card slot to warn others not to eject the SD
card freely.
Caution: You should back up the old data in the SD card before inserting it into
the slot, as the system will automatically format the card in one minute.
To remove an SD card, take the following steps:
1. Run the command ex e c d e t a c h s d 0 on the CLI interface.
2. Face the front panel of the appliance.
3. Rip off the label stuck on the slot.
4. Push the SD card slightly and it will pop up.
Note: Hillstone adopts the Secure Digital High Capacity (SDHC) standard. To
ensure the requirements of capacity and storage writing speed, the SD card
should at least have a capacity of 4GB and a speed of Class 4 (4 MB/s). The