User Manual

22
Chapter 1 Introduction | Hillstone
Hillstone Multi-core Security Appliance Installation Manual
Attribute
Description
Short-haul
Multimode
Optical
Module
(850nm)
Medium-
haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1550nm)
Ultra-long
Haul
Single-
mode
Optical
Module
(1550nm)
Connector
LC
Fiber Type
62.5/125μm
multi-mode
fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
Maximum
Transmission
Distance
0.55km
10km
40km
40km
70km
Central
Wavelength
850nm
1310nm
1310nm
1550nm
1550nm
Table 1-25: SFP Optical Module Attributes
If you choose to use copper SFP transceiver in SFP port, you should use crossover
or straight-through cable (i.e. standard Ethernet cable). Table 1-16 describes the
attributes of copper SFP transceiver.
Attribute
Description
Connector
RJ-45
Port Standard
Auto-MDI/MDIX (crossover cable and straight-through
cable autosensing)
Maximum Transmission
Distance
100m
Negotiation Mode
10/100/1000Mbps autosensing (some only supports
1000Mbps)
Full / half-duplex
Table 1-26: SFP Copper Module Attributes
Cautions:
 The SFP electric modules of all platforms only support 1000Mbps.
 Before switching between the optical and copper cable connection on
Combo ports, you need to first clear the rate and duplex mode
configurations in the current operating mode (copper or optical), and re-
configure the port after the switching.
XFP Port
Hillstone multi-core security appliances support XFP ports which use XFP optical
modules.