User Manual

Hillstone Hardware Reference Guide
Figure 3-7: Connecting the Ethernet Fiber Cable
Warning: Laser danger! To protect your eyes from radiation harm, do not
stare into a cable connector connected to a laser generator.
Connecting a Power Adapter
To provide the power supply, connect the power adapter of the devices with the
external AC power supply as follows:
1. Insert the DC output plug of the power adapter into the AC power interface at
the back panel of the device.
2. Connect the power adapter to the external AC power supply.
Verifying Installation
After you complete the installation with all the above steps, you still need to verify
the following items.
♦ All the cables are properly connected.
♦ The grounding wire of the device is correctly connected.
♦ The air vents on both side panel of the device are unblocked, and there is
enough space around for heat dissipation.
♦ The expansion modules, power supply modules and fan tray are correctly
installed (for some products).
♦ The power source meets the requirements of the device.
♦ If the device is rack-mounted, make sure the rack is stable enough. If the
device is placed on a workbench, make sure the workbench is stable and
clean.
16
Chapter 3 Installation
| Hillstone