User Manual

Hillstone Hardware Reference Guide
module connected by a single-mode or multi-mode cable. The XFP port uses single-
mode or multi-mode cables to access Ethernet.
All SFP Port and XFP Port
optical modules of Hillstone products use LC-type optical
connector; therefore, you should connect the optical modules using optical fiber
ended with LC-type connector.
Connecting the Ethernet Copper Cable
Follow the guidelines below when connecting cables to the ports:
♦ Be careful not to connect the Ethernet port to the wrong ports. Read the label
above the port carefully.
♦ For electrical Ethernet connection, use crossover cable or straight-through
cable.
Figure 3-6: Connecting the Ethernet Copper Cable
Connecting the Ethernet Fiber Cable
Follow the guidelines below when connecting cables to the ports:
♦ Be careful not to connect the Ethernet port to the wrong ports. Read the label
above the port carefully.
♦ For SFP port connection, the optical module should be inserted into SFP port
before installing the LC-type connector to the optical module; the copper SFP
module should be connected by crossover cable or straight-through cable.
♦ For XFP ports, insert the XFP optical module into the XFP port before
connecting the LC-type connector to the module.
Keep the followings in mind when connecting fiber cables:
♦ The curvature radius should be greater than 10cm. Avoid excessive bending
of the cable.
♦ Ensure the Tx and Rx ends are connected correctly.
♦ Keep the connector of the optical cable clean.
15
Chapter 3 Installation
| Hillstone