User Manual

Hillstone Hardware Reference Guide
Figure 3-3: Installing the Rack-mounting Ears (1U Chassis as example)
Step 3: Take out screws from the accessory box and fasten the rack-mounting ears
of the chassis in the rack with the screws. Keep the center of the rack-mounting ear
and the center of the rack hole horizontally even, as shown in Figure 3-4.
Figure 3-4: Installing the Device in a Rack (1U Chassis as example)
Cautions:
♦ The rack-mounting ears cannot bear weight. Make sure the chassis is
supported by the platform under it when mounted into a rack.
♦ For better ventilation, there should be a clearance space between two
equipments.
♦ If the rack accommodates only one device, put the device on the
bottom.
♦ The floating nuts in the accessory box can only fit in the 9mm x 9 mm
squared holes of standard racks and they can be used when no original
rack nuts are available.
Connecting Cables
This section describes how to connect cables to the device, including connecting the
ground wire, the console cable, the Ethernet cable and the power cable.
13
Chapter 3 Installation
| Hillstone