User's Manual

Chapter 5 Hardware Maintenance and Replacement | Hillstone

Hillstone Multi-core Security Appliance Installation Manual

Chapter 5 Hardware Maintenance and Replacement

Introduction

This chapter explains how to install and remove the power supply module, the

expansion module and the fan tray.

Installing and Removing the Power Supply Module

This section describes how to install and remove the power supply module of SG-

6000-G5150, SG-6000-M8860, and SG-6000-M7260. Take the following steps to

install or remove the power supply module:

Installing/Removing the Power Supply Module (G5150/ M8860/ M7260)

To install a power supply module to SG-6000-G5150, SG-6000-M8860, or SG-

6000-M7260, take the following steps:

1. Ensure that the power supply module to be used is not connected to any

power source.

2. Face the back panel of the appliance.

3. If the power supply slot is covered by blank plate, remove the plate first

(unscrew the screws on the blank plate and take it down). Skip this step if the

slot is not covered.

4. Slide the power supply module all the way into the slot cage until you feel

resistant.

Figure 5-1: Installing Power Supply Module of SG-6000-G5150 /M8860/

M7260

To remove the power supply module:

1. Make sure the power supply module to be used is not connected to any supply

source.

2. Face the back panel of the appliance.

3. Pull the power supply straight out of the chassis using the provided handle.