User's Manual

Chapter 4 Boot and Configuration | Hillstone

Hillstone Multi-core Security Appliance Installation Manual

Figure 4-2: Setting Parameters for the Terminal Session

3. Switch on the power supply, and the appliance performs self-test and

initializes the configuration automatically. If the booting succeeds, the system

will display the command line prompt “login”. Enter the default administrator

name and password “hillstone” at the “login” and “password” prompts, press

“Enter”. And now you are successfully logged in and accessing the CLI.

4. Enter commands to configure or view running status. Enter a question mark

“?” to get help on commands whenever you want.

WebUI

The ethernet0/0 (e0/0) port has a default IP address of 192.168.1.1/24, and all the

management functions of this port are enabled by default. Administrators can

access the WebUI through e0/0.

To log in the appliance’s WebUI, take the following steps:

1. Set up the IP address of the management PC on the same subnet as

192.168.1.1/24. Connect the management PC to the e0/0 port through an

Ethernet cable.

2. Launch a Web browser of the management PC, enter the URL

http://192.168.1.1 in the address bar, and then press Enter.

3. Enter the default administrator name and password “hillstone” in both the

4. Click the Login button to enter WebUI main page. Then you can set other

configurations to the appliance.