User's Manual

35
Chapter 3 Installation | Hillstone
Hillstone Multi-core Security Appliance Installation Manual
Warning: Before performing the procedure, ensure that the cable is not connected
with any power source and make sure the cables will not be powered on during the
process.
To connect the DC power cable to the appliance, take the following steps:
1. Ensure that the power source voltage is in accordance with required voltage
specified in System Parameters.
2. Switch off the power source.
3. If the terminal on the power supply module has a plastic cover, remove the
cover and keep it.
4. Connect the grounding screw (labeled with “ ”) to the ground contact point
using a grounding wire.
5. Use DC cables to connect the “+” terminal of the appliance to the “+”
terminal of the power source, and “-” terminal to the “-” terminal of the
source.
6. Verify the connection is correct and fasten the cables using a screwdriver.
7. Recover the plastic cover(s) to the original terminal(s).
8. To connect more DC power cables, repeat Step3 to Step7.
9. Switch on the power supply module.
10. Switch on the power source and check if the PWR LED is on. A shining LED
indicates correct connection.
Connecting a Power Adapter
To provide the power supply, connect the power adapter of the security appliances
with the external AC power supply as follows:
1. Insert the DC output plug of the power adapter into the AC power interface at
the back panel of the security appliance.
2. Connect the power adapter to the external AC power supply.
Installing an Antenna
To use the WLAN function or the 3G function of the device, you must install the
WLAN antenna or the 3G antenna. You can adjust the angle of the WLAN antenna
by rotating it. The angle of the 3G antenna is fixed. The antennas are shown as
below: