User's Manual

23
Chapter 1 Introduction | Hillstone
Hillstone Multi-core Security Appliance Installation Manual
Attribute
Description
Connector
XFP
Frame Format
Ethernet_II
Ethernet_SNAP
Negotiation Mode
XFP optical module
10Gbps
Table 1-27: XFP Port Attributes
Hillstone multi-core security appliance supports five types of 10GBase-FX XFP
optical module. All optical modules are hot-swappable.
Attribute
Description
Short-
haul
Multimode
Optical
Module
(850nm)
Short-haul
Multimode
Optical
Module
(850nm)
Medium-
haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1550nm)
Ultra-long
Haul
Single-
mode
Optical
Module
(1550nm)
Connector
LC
Fiber Type
50/125μm
multimode
fiber
62.5/125μm
multi-mode
fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
Maximum
Transmission
Distance
0.3km
(984.3ft)
0.033km
(108.3ft)
10km
40km
80km
Central
Wavelength
850nm
850nm
1310nm
1550nm
1550nm
Table 1-28: XFP Optical Module Attributes
Caution: To avoid dust falling into the XFP socket, you should place a rubber dust cap
(originally in the accessory box) over the XFP port.
CLR Button
The CLR button is the pinhole of the front panel and is used to reset the appliance
back to the factory default settings. You can restore access to the appliance with
this button if the login password is lost.
Warning: Use this button with caution. Resetting the appliance will clear all existing
configurations.
To restore the factory default settings, take the following steps:
1. Turn off the power of the appliance.
2. Press the CLR button in the pinhole and switch on the power supply
simultaneously.
3. Keep pressing till the STA and ALM LEDs turn to constantly red, then stop
pressing. The appliance begins to restore to the original factory settings.
4. The system reboots after the default settings restored.