Reference Guide

3. Switch on the power supply, and the device performs self-test and initializes the

configuration automatically. If the booting succeeds, the system will display the command

line prompt "login". Enter the default administrator name and password "hillstone" at the

"login" and "password" prompts, press Enter. And now you are successfully logged in

and accessing the CLI. After login, please change the default password of the device in

time.

4. Enter commands to configure or view running status. Enter a question mark "?" to

get help on commands whenever you want.

WebUI

The MGT port has a default IP address of 192.168.1.1/24, and all the management functions of this

port are enabled by default. Administrators can access the WebUI through the MGT port.

To log in the device's WebUI, take the following steps:

1. Set up the IP address of the management PC on the same subnet as 192.168.1.1/24.

Connect the management PC to the MGT interface through an Ethernet cable.

 If the device has a MGT0 interface, connect the cable to this interface.

 If the device does not have a MGT0 interface, connect the cable to the e0/0

interface.

2. Launch a Web browser of the management PC, enter the URL https://192.168.1.1

in the address bar, and then press Enter.

3. Type the default administrator name (hillstone) and password (hillstone) into the text

boxes respectively.