Reference Guide

14
Attribute
Description
Maximum
Transmission
Distance
100m
Negotiation
Mode
10/100/1000Mbps autosensing (some only supports 1000Mbps)
Full/half-duplex
CLR Button
The CLR button is the pinhole of the front panel and is used to reset the device back to the factory
default settings. You can restore access to the device with this button if the login password is lost.
Notes: Use this button with caution. Resetting the device will clear all existing configurations.
To restore the factory default settings, take the following steps:
1. When the device is working, use a pin to press the CLR button in the pinhole and
the device will restart.
2. After the device restarts, the CON port outputs the information of CLR button
pressed and the STA and ALM LEDs turn solid red. After the LEDs turn off, the device
will restart again.
Power Supply
Table: Power Supplies of All Product Models
Model
Single/Dual
AC/DC
Power Supply Type
A200 series
Single
DC
External power adapter
Power Supply Modules
A200 uses a pluggable AC power adapter.
A200 AC Power Supply Module: