Instructions / Assembly

Assembly Steps:
Step 1: Place Slate Top (E) upside down on a protected flat surface. Then
attach one Corner Posts with Side Panel (F) to Slate Top (E) by using M6x12
Bolt (J) screw. Hand tighten bolts,But do not fully tighten. Repeat for
another Corner Posts with Side Panel (F) . (See FIG 1)
Step 2: Attach one Side Panel (G) between two Corner Posts with Side Panel
(F) by using 4 M6 x18 Bolts (K) and Nuts (L). Hand tighten bolts,But do not fully
tighten. Repeat for another Side Panel (G). (See FIG 2)
Step 3: Check alignment and make any necessary adjustments.Tighten all bolts
with screw driver.
Step 4: Assemble the Screen (B) by using Lift Handle (A) and M6 Nut (L).
(See FIG 3)
Step 5: Turn the assembled table top to upright position, put Fire Bowl (D) onto the
Slate Top (E) and place Log Grate(C) into Fire Bowl (D). (See FIG 4), Finally put
the screen (B) on the fire bowl. (See FIG 5),
Your fire pit is ready for use now. Once fire pit has cooled after use ,use
cover to protect against rain and dust .
Page 5 of 6