Installation Guide
Table Of Contents
- Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so may result in a fire, explosion, injury or death.
- NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.
- Combustible materials should not be within 72 inches of the top of the unit, or within 48 inches around the entire unit.
- 1. Place 2 Screw(AA) onto threaded part of handle (D). Insert handle (D) into holes on top of the lid (A).
- Propane tank must be a minimum of 60 inches away at all times.
- Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion you must replace the hose. Pumice stones/lava rocks could pop up and strike during the process of lighting this unit; stand away from the unit for the ...
- • Before performing any maintenance always disconnect the propane gas tank.
- • Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
ASSEMBLY INSTRUCTIONS
Page 7
1.
Place 2 Screw(AA) onto threaded part of
handle (D). Insert handle (D) into holes on top of
the lid (A).
2.
From the underside of the lid (A), place 2 pcs
washers (BB) onto threaded part of the handle
(D). Secure with 2 M6 nuts (CC), tightening with
wrench (E).
3.
Place pumice stones (C) into body (B).
CAUTION
To ensure proper function, the screen on this
burner should be free of pumice stones at all
times.
D
BB