Installation Guide
Table Of Contents
- Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so may result in a fire, explosion, injury or death.
- NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.
- Combustible materials should not be within 72 inches of the top of the unit, or within 48 inches around the entire unit.
- 1. Place 2 Screw(AA) onto threaded part of handle (D). Insert handle (D) into holes on top of the lid (A).
- Propane tank must be a minimum of 60 inches away at all times.
- Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion you must replace the hose. Pumice stones/lava rocks could pop up and strike during the process of lighting this unit; stand away from the unit for the ...
- • Before performing any maintenance always disconnect the propane gas tank.
- • Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
SAFETY INFORMATION
Page 4
Only use the regulator and hose assembly provided with this unit. Replacement parts must be
supplied directly by the Manufacturer.
Inspect the burner before each use of this unit. If the burner shows any kind of damage, do not
operate the appliance. For assistance with repair or replacement of the burner or any other
parts, please call the manufacturer.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Combustible materials should not be within 72
inches of the top of the unit, or within 48 inches
around the entire unit.
Min. Clearance
48 in (121.9 cm)