Installation Guide
Table Of Contents
- Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so may result in a fire, explosion, injury or death.
- NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.
- Combustible materials should not be within 72 inches of the top of the unit, or within 48 inches around the entire unit.
- 1. Place 2 Screw(AA) onto threaded part of handle (D). Insert handle (D) into holes on top of the lid (A).
- Propane tank must be a minimum of 60 inches away at all times.
- Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion you must replace the hose. Pumice stones/lava rocks could pop up and strike during the process of lighting this unit; stand away from the unit for the ...
- • Before performing any maintenance always disconnect the propane gas tank.
- • Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
Page 3
•
Combustible material should not be within 72 inches of the top of the unit, or within 48 inches
around the entire unit.
•
If the flame goes out while burning, turn the gas valve off. Wait 5 minutes before repeating the initial
lighting procedure.
•
Do not add water into the unit.
•
Do not operate unit if any part has been under water.
•
Do not disconnect any part while unit is in use.
•
Do not store a spare propane tank on or near this unit.
•
If the appliance is being stored indoors, detach the propane tank and leave outdoors.
•
Always remove protective cover before operating the unit.
•
Do not set the protective cover over the unit until it is turned off and completely cooled down.
•
Check for leaks after not using the unit for long periods of time.
•
Children should never operate this unit. Children must be supervised while near this unit.
•
Keep gas tank at least 5 feet away from unit when lit. (if external tank)
•
The maximum gas supply pressure is 250psi.
•
Inspect all elements of this heating unit before each use. If there is damage, the burner must be
replaced.
•
Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)
•
Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or
injury.
•
The gas supply tank should be constructed and marked with the specifications for the LP gas tanks
•
The LP gas tank must have a listed overfilling prevention device and a QCCI or Type I, (CGA810) LP
gas
tank connection.
•
This appliance should not be used on plastic or artificial wood desks.
•
Children and adults should be alerted to the hazards of high surface temperatures and should
s
tay away to avoid burns or clothing ignition.
•
Clothing or other flammable materials should not be hung from the appliance or placed on or
near the appliance.
•
Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
•
Installation and repair should be done by a qualified service person. The appliance should be
inspected before use and at least annually by a qualified service person. More frequent cleani
ng
m
ay be required as necessary. It is imperative that the control compartment, burners a
nd
ci
rculating airways of the appliance are kept clean.
•
Allow heating item to cool completely before placing on lid.
•
DO NOT use appliance while lid is installed. Always remove the lid while heating item is in use.