User Manual

Network Camera User Manual
11
Network Connection
Note:
 You shall acknowledge that the use of the product with Internet access might be
under network security risks. For avoidance of any network attacks and
information leakage, please strengthen your own protection. If the product does
not work properly, please contact with your dealer or the nearest service center.
 To ensure the network security of the network camera, we recommend you to
have the network camera assessed and maintained termly. You can contact us if
you need such service.
Before you start:
 If you want to set the network camera via a LAN (Local Area Network), please refer
to 2.1 Setting the Network Camera over the LAN.
 If you want to set the network camera via a WAN (Wide Area Network), please
refer to 2.2 Setting the Network Camera over the WAN.
Setting the Network Camera over the LAN
Purpose:
To view and configure the camera via a LAN, you need to connect the network camera
in the same subnet with your computer, and install the SADP or iVMS-4200 software
to search and change the IP of the network camera.
Note: For the detailed introduction of SADP, please refer to Appendix 1 SADP Software
Introduction.
2.1.1 Wiring over the LAN
The following figures show the two ways of cable connection of a network camera and
a computer:
Purpose: