User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Wi-Fi Settings
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- Chapter 7 Network Settings
- 7.1 Configuring Basic Settings
- 7.2 Configure Advanced Settings
- 7.2.1 Configuring SNMP Settings
- 7.2.2 Configuring FTP Settings
- 7.2.3 Configuring Email Settings
- 7.2.4 Platform Access
- 7.2.5 Wireless Dial
- 7.2.6 HTTPS Settings
- 7.2.7 Configuring QoS Settings
- 7.2.8 Configuring 802.1X Settings
- 7.2.9 Integration Protocol
- 7.2.10 Bandwidth Adaptation
- 7.2.11 Network Service
- 7.2.12 Smooth Streaming
- 7.2.13 Security Control Panel Configuration
- Chapter 8 Video/Audio Settings
- Chapter 9 Image Settings
- Chapter 10 Event Settings
- Chapter 11 Storage Settings
- Chapter 12 Playback
- Chapter 13 Picture
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Port Mapping
- Appendix 3
Network Camera User Manual
118
Steps:
1. Enter the Flashing Alarm Light Output settings interface: Configuration > Event >
Basic Event > Flashing Alarm Light Output.
Flashing Duration: The time period the flashing lasts when one alarm happens.
Flashing Frequency: The flashing speed of the light. High, Medium, and Low are
selectable.
2. Set the flashing duration and flashing frequency.
3. Edit the arming schedule.
4. Click Save.
Note: Only certain camera models support the function.
10.1.7 Configuring Audible Alarm Output
Audible Alarm Output Settings
Steps:
1. Enter the Audible Alarm Output settings interface: Configuration > Event > Basic