User Manual

Network Camera User Manual
117
1. Enter the Alarm Output Settings interface: Configuration> Event > Basic Event >
Alarm Output.
2. Select one alarm output channel in the Alarm Output drop-down list. You can also
set a name for the alarm output (optional).
3. Set delay time. The delay time refers to the time duration that the alarm output
remains in effect after alarm occurs.
4. Click Arming Schedule to enter the Edit Schedule Time interface. The time
schedule configuration is the same as the settings of the arming schedule for
motion detection Refer to Task 2: Set the Arming Schedule for Motion Detection
in 10.1.1 Configuring Motion Detection.
5. You can copy the settings to other alarm outputs.
6. Click Save to save the settings.
Note: Only certain camera models support the function.
10.1.5 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the cameras.
Steps:
1. Enter the Exception Settings interface: Configuration > Event > Basic Event >
Exception.
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to Task
3: Set the Linkage Method for Motion Detection in 10.1.1 Configuring Motion
Detection.
3. Click Save to save the settings.
Configuring Flashing Alarm Light Output
Flashing Alarm Light Output Settings