User's Manual

7.8 Set Access Control Parameters
You can set the access control permissions, including the funcons of authencaon mode, enable
M1 card, door contact, open duraon (s) and authencaon interval (s).
On the Home pag
e, tap ACS (Access Control Sengs) to enter the Access Control Sengs page.
E
dit the access control parameters on this page.
The available parameters descripons are as follows:
Table 7-2 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
●
Only the de
vice with the ngerprint module supports the
ngerprint related funcon.
●
Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use mulple authencaon modes.
●
If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
Enable M1 Card Enable the funcon and you can present the M1 card to
authencate.
Door Contact You can select "Open (Remain Open)" or "Close (Remain
Closed)" according to your actual needs. By default, it is Close
(Remain Closed).
Open Duraon Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked. Available door locked me
range: 1 to 255s.
Authencaon Interval Set the device authencang interval. Available authencaon
interval range: 0 to 65535.
DS-K5671B Series Face Recognion Terminal User Manual
72