User's Manual

3.
Edit the employee ID.
Note
●
The emplo
yee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper leers, and numbers.
●
The employee ID should not be duplicated.
4.
T
ap the Name eld and input the user name on the so keyboard.
Note
●
Number
s, upper case leers, lower case leers, and special characters are allowed in the user
name.
●
Up to 32 characters are allowed in the user name.
5.
Oponal: Add a f
ace picture, and cards for the administrator.
Note
●
F
or details about adding a face picture, see
Add Face Picture .
●
F
or details about adding a card, see
Add Card .
●
F
or details about adding a PIN, see
View PIN code .
6.
Oponal: Se
t the administrator's authencaon type.
Note
For details about seng the
authencaon type, see
Set Authencaon Mode .
7.
Se
t the user role as Administrator
8.
Tap
to save the
sengs.
7.3.2 Add Face Picture
Add user's face picture to the device. And the user can use the face picture to authencate.
Steps
1.
Long t
ap on the inial page for 3 s and slide to the le/right by following the gesture and log in
the backend.
2.
Tap User → + to enter the Add User page.
3.
Edit the employee ID.
Note
●
The emplo
yee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper leers, and numbers.
●
The employee ID should not be duplicated.
4.
T
ap the Name eld and input the user name on the so keyboard.
DS-K5671B Series Face Recognion Terminal User Manual
60