User's Manual

3.
Select the event(s) and click Edit Priority to dene the priority for the event(s), which can be
used to lter events in the Event Center.
4.
Set the linkage acons of the event.
1) Select the event(s) and click Edit Linkage to set the client acons when the event(s) are
trig
gered.
Audible Warning
The client soware gives an audible warning when the event is triggered. You can select
alarm sound f
or the audible warning.
Note
For details about seng the alarm sound, refer to Se
t Alarm Sound in the user manual of
the client soware.
Send Email
Send an email nocaon about the event to one or more receivers.
F
or details about seng email parameters, refer to Set Email Parameters in the user
manual of the client soware.
2) Click OK.
5.
Enable the event so that when the event is detected, event will be sent to the client and the
linkage acons will be triggered.
6.
Oponal: Click Cop
y to to copy the event sengs to other access control device, alarm input,
door, or card reader.
9.8.2 Congure Device Acons for Access Event
You can set the access control device's linkage acons for the access control device's triggered
event. When the event is triggered, it can trigger the alarm output, host buzzer, and other
acons
on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Con
trol → Linkage Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add buon to add a new linkage.
4.
Select the e
vent source as Event Linkage.
5.
select the event type and detailed event to set the linkage.
6.
In the Linkage Target area, set the property target to enable this acon.
Buzzer on Controller
The audible w
arning of access control device will be triggered.
DS-K5671B Series Face Recognion Terminal User Manual
177