User's Manual

Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended accesss
needs swipes her/his card.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Note
●
The dur
ess code and the super code should be dierent.
●
The duress code and super password should be dierent from the authencaon password.
●
The length of duress code and the super password is according to the device, usually it should
contains 4 to 8 digits.
5.
Click OK.
6.
Oponal: Click Cop
y to , and then select the door/oor(s) to copy the parameters in the page to
the selected doors/oor(s).
Note
The door's status duraon
sengs will be copied to the selected doors as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
St
eps
1.
Click Access Control → Advanced Funcon → De
vice Parameter .
2.
In the device list on the le, click
to expand the door, select a card reader and you can edit the
c
ard reader's parameters on the right.
3.
Edit the card reader basic parameters in the Basic Informaon page.
Note
●
The displa
yed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Basic Informaon
Name
E
dit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less than the set value, the card
swiping is invalid. You can set it as 0 to 255.
DS-K5671B Series Face Recognion Terminal User Manual
160