User's Manual

Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM c
ard funcon.
4.
Click OK.
5.
Oponal: Click Cop
y to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure Parameters for Door
Aer adding the access control device, you can congure its access point door parameters.
Steps
1.
Click Access Control → Advanced Funcon → Device Parameter .
2.
Select an access control device on the le panel, and then click
to show the doors of the
select
ed device.
3.
Select a door to show its parameters on the right page.
4.
Edit the door parameters.
Note
The displayed parameters may vary for dierent access control devices.
●
●
Some of the f
ollowing parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Name
E
dit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit
Buon Type
You can set the exit buon as remaining closed or remaining open. Usually, it is remaining
open.
Open Duraon
Aer swiping the normal card and relay acon, the
mer for locking the door starts working.
Super Password
The specic person can open the door by inpung the super password.
Door Le Open Timeout Alarm
The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Click Advanced to congure more parameters.
DS-K5671B Series Face Recognion Terminal User Manual
159